Front Panel Setup - Cisco D9054 Installation And Operation Manual

Front Panel Setup

Locking/Unlocking the Front Panel
The front panel can be locked or unlocked using either the front panel keypad or the
Web interface.
Proceed as follows to unlock the front panel using the front panel keypad:
1. Press MENU.
2. Navigate to Lock in the LCD display and press the SELECT key.
3. If the front panel is presently locked, the cursor will flash on the first character of
'Locked'.
4. Press the left arrow key to change the current state to 'Unlocked' and then press
the Select key.
5. You will be prompted to confirm your selection. Use the right arrow to display
'Yes' and then press the Select key.
6. The front panel will now be unlocked allowing you to change the IP address.
To lock the front panel, perform the same procedure, except use the right arrow key
to change the state. In this case you will not be prompted to confirm the operation.
Note: To control this feature using the Web Interface, refer to Reading the System
Information or Managing the System in Chapter 5.
Setting Up the IP Parameters of the D9054 HD Encoder
Follow the procedure below when a D9054 HD Encoder is added to or reinserted in
the installation.
Proceed as follows to set the IP parameters of the Management port of the D9054
HD Encoder:
1. Press the MENU key on the front panel of the D9054 HD Encoder.
The MENU key toggles between the start up display and the main menu.
2. From the main menu press the RIGHT arrow key and navigate over to the
System menu and press the SELECT key.
3. Press the RIGHT arrow key and navigate over to the IP sub-menu and press the
SELECT key.
You have now entered the IP menu.
4. Go to the required menu item and press SELECT to access the IP Address, Mask
and Gateway. Use the right and left arrow keys to navigate the IP sub-menu and
if necessary, change any of the values.
Use the right arrow key to navigate to the digits you want to change and press a
numeric key to enter a value. Press the SELECT key to store the entered value(s).
5. If necessary, change the other IP parameters as described in steps 3 and 4 above.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide 1-3