Section C - Setting Up The Audio - Cisco D9054 Installation And Operation Manual

To Enable Audio Channels
Proceed as follows to select and enable audio channels:
1. From the user interface of the D9054 HD Encoder, click the Audio tab.
2. Select and enable the audio channel(s) you want to use by clicking on the cell in
the table. The arrow in the table cell will change colour from grey to green when
it is selected. Select from either Layer II, Dolby Digital, AAC or Linear/Dolby-E.
Note: When audio channels are enabled or disabled in this window, they will
appear in the same state as in their individual channel windows. You can choose
to enable or disable each channel in this window or the individual audio
channel windows.
3. Click Apply.
5-44

Section C - Setting Up the Audio

D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A