Cisco D9054 Installation And Operation Manual page 77

Output Menu,
Continued
IP Output
Parameters:
Description:
IP Output, Enable Main
Parameters:
Description:
IP Output, Enable Backup
Parameters:
Description:
IP Output, IP Mode
Parameters:
Description:
IP Mode, <Sn>
Parameters:
Description:
4038938 Rev A
Enable Main, Enable Backup, or IP Mode.
Select Enable Main if you want to enable/disable IP data from the
IP TS OUT 1 connector. Select Enable Backup if you want to enable/
disable IP data from the IP TS OUT 2 connector. Select IP Mode if
you want to set the mode for the eight services on the IP TS OUT 1
and IP TS OUT 2 connectors.
Disable, Enable
Select Enable to stream data to the main receiver from the IP TS
OUT 1 connector.
If you select Disable, there will be no output on the IP TS OUT 1
connector.
Note: You have to use the web GUI or the ROSA interface to set up
the MAC and IP addresses of the receiver of the IP streaming
packets.
Disable, Enable.
Select Enable to stream data to the backup receiver from the IP TS
OUT 2 connector.
If you select Disable, there will be no output on the IP TS OUT 2
connector.
Note: You have to use the web GUI or the ROSA interface to set up
the MAC and IP addresses of the receiver of the IP streaming
packets.
S1, S2, S3, S4, S5, S6, S7, S8.
Select the service.
Disable, UDP, or RTP.
For the service selected, select the IP streaming mode.
Note: You have to use the web GUI or the ROSA interface to set up
the MAC and IP addresses of the receiver of the IP streaming
packets.
D9054 HDTV Encoder Intstallation and Operation Guide 4-23