Cisco D9054 Installation And Operation Manual page 233

Message Description and Remedy
DPI stop without Description: An external control signal
start occurred out of sequence. A Start
command must be triggered before it can
be stopped.
Remedy: Setup of automation system
may need to be corrected.
DPI cancel Description: An external control signal
without start occurred out of sequence. A Start
command must be triggered before it can
be cancelled.
Remedy: Setup of automation system
may need to be corrected.
Description: The relative delay setting has
DPI PTS delay
made the "splice_time()" PTS value to
invalid
reference a point in time that has already
occurred.
Remedy: Change relative delay
parameters.
DPI Message Description: The general purpose input
trigger ignored detected multiple triggers too close
due to debounce together in time.
delay
Remedy: Reduce the debounce delay
setting, or increase the time between
triggers or provide debounce protection
to the general purpose input.
DPI Transport Description: Data was lost when
packet overflow attempting to load a DPI message to the
buffer.
Remedy: Increase the DPI bit rate.
Embedded closed Description: There is no closed captions
captions input data embedded in the HD SDI input.
loss Remedy: Examine the video input signal.
Encoding Description: The internal MPEG
processing error processing of the encoder failed. The
encoding will restart.
Remedy: Check your settings for
parameter violations. Observe the
limitations in the manual. If persistent,
contact the closest Cisco customer
support center for assistance.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide
Severity Default
Alarm
Category
Minor B
Minor B
Minor B
Minor B
Minor B
Major B
Major B
Enable
On
On
On
On
On
On
On
6-11