Setting Up Statistical Multiplexing - Cisco D9054 Installation And Operation Manual

Setting Up Statistical Multiplexing

Before You Begin
To make it easier to identify each encoder and its role in the Statistical Multiplexing
pool, ensure that each encoder is assigned a unique system name, its video service
is assigned a unique PID, and unique service ID.
Note: You need a statmux license for each D9054 HD Encoder that runs in statmux
mode.
Note: Ensure that all video programs are frame synchronized by an External Frame
synchronizer (i.e., set Frame Synchronization to External Reference).
Note: An external black burst reference must be used if using a mix of interlaced
and progressive video formats.
Refer to Setting Up the Video Input, page 5-12 for more information.
Proceed as follows to set up the Statistical Multiplexing Network Interface:
1. From the user interface of the D9054 HD Encoder click the Video tab, expand
the H.264 icon, expand the Statistical Multiplexing icon and click the Network
Interface icon from the sub-pages.
2. Select the communication port, either Management, IP Main or IP Backup. The
Encoder uses the Management port as the default.
Note: If you select or change the Network Interface to either IP Main or IP
Backup port, you must power-cycle the encoder before communication at either
of the ports in functional.
3. Click Apply.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide 5-25