Setting Up The Ip Streaming Output - Cisco D9054 Installation And Operation Manual

Setting Up the IP Streaming Output

The D9054 HD Encoder can stream IP to an IP network device with a defined MAC
address and IP address on a selected IP subnet.
Setup in the D9054 HD Encoder ROSA/Web Interface
Proceed as follows to set up the IP Streaming Output:
1. From the user interface of the D9054 HD Encoder, click the TS Output tab and
the IP Streaming icon from the sub-pages.
The D9054 HD Encoder GUI automatically displays the output payload rate of
the IP streaming. This rate depends on how many IP streams you have enabled
in the Stream Setup picture and whether or not you have enabled the Maintain
the TS Rate setting.
This page also displays the mode for each of up to 8 IP output streams, the total
output bit rate, the used bit rate and the free (available) bit rate for each stream.
The GUI displays the bit rate of the used payload if you press Reload.
2. Select Enable Main Output to stream data to the main receivier from the IP TS
OUT 1 connector. If Enable Main Output is de-selected, there will be no output
on the IP TS OUT 1 connector.
3. Select Enable Backup Output to stream data to the backup receiver from the IP
TS OUT 2 connector. If Enable Backup Output is de-selected, there will be no
output on the IP TS OUT 2 connector.
5-98 D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A