Setting The Clock Synchronization - Cisco D9054 Installation And Operation Manual

Setting the Clock Synchronization

Proceed as follows to set the Clock Synchronization:
1. From the user interface of the D9054 HD Encoder, click the System tab, expand
the Clock icon and click the Synchronization icon from the sub-pages.
ROSA displays the existing clock synchronization of the D9054 HD Encoder.
2. Select Enable Sychronization to enable the synchronization.
This means that the D9054 HD Encoder will synchronize to the clock of the
Copernicus server/ROSA PC or any other time server with the address
specified in the Server Address field. Only the TCP based daytime service is
implemented as defined in the RFC 867.
Hint: To use the Time/Clock synchronization with a ROSA Single-User/DCS,
you must run a custom setup. This is installed by default on the Copernicus
server/ROSA PC.
3. Type the synchronization Interval in minutes.
The Copernicus/ROSA PC clock is automatically downloaded to the encoder at
the specified interval, starting when you Click Apply. To synchronize once a
day at 1 o'clock am set the interval to 1440 min. and Start Time to 01:00.
4. Type the synchronization Offset in minutes. The range is from -1440 to 1440.
This field is used when the clock server is located in a different time zone than
the encoder.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide 5-133