Cisco D9054 Installation And Operation Manual page 26

Connecting the Units,
6. Connect the MANAGMENT port on the D9054 HD Encoder to the Ethernet
LAN.
For further information, see Connecting the Ethernet Management Interface,
page 3-11.
7. Connect the DATA 1 and DATA 2 connectors from the equipment after the
D9054 HD Encoder to the IP TS OUT 1 and IP TS OUT 2 ports.
The equipment after the D9054 HD Encoder is typically an IP set top box.
8. Connect the output signal from the D9054 HD Encoder ASI MONITOR port to
an ASI monitor.
9. Connect the power sources of all the units.
For further information, see the specific product manuals in question. When
connecting the power source to the D9054 HD Encoder it takes less than a
minute for the unit to initialize. The front panel display shows the startup
display.
1-2
Continued
D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A