Section C - Connecting the Input/Output Signals
Connecting the Video and Reference Signal Inputs
Connectors for the Video and Reference Signal Inputs
Both the SDI, composite video input and reference input connectors are of the BNC
type and are internally terminated.
The following video and reference input signals are supported:
• 270 Mbit/s digital 525 and 625 lines SDI, or
• Analog composite PAL (B, D, G, H, I , K, M, N) , NTSC system M and J-NTSC
• Composite reference input
To Connect to the Video Input
Do as follows to connect to the video input:
1. Connect the video input signal to the SDI In or Composite In connector.
Use a 75-ohm double-braided coax cable.
To Connect the Reference Input
Do as follows to connect to the reference input:
1. Connect the reference input signal to the REF IN connector.
Use a 75-ohm double-braided coax cable.
4020024 Rev C
Installation
3-7