Cisco D9054 Installation And Operation Manual page 230

Message Description and Remedy
Can't enable Description: The enabled option has not
option as it is not been properly installed.
installed
Remedy: Order the needed licence
through the closest Cisco customer
support center.
Clock Description: Synchronization with the
synchronization specified clock server has failed.
failed
Remedy: Check the IP address for the
clock server and the IP routing. Also
check that the time server uses the RFC
867 (Day Time Protocol).
Description: The encoder failed to lock to
Dolby Digital:
the audio frame or the audio sample
Audio input loss
frequency is out of range.
Remedy: Check the cable and the
incoming signal.
Dolby Digital: Description: The incoming passthrough
Detected change rate has changed due to a change in the
in incoming audio program content.
passthrough rate
Remedy: Check whether changes in
audio content are expected. The message
serves as information only.
Dolby Digital: Description: The encoder failed to lock to
Digital audio the audio frame or the audio sample
input error frequency is out of range.
Remedy: Check the cable and the
incoming signal.
Description: The encoder failed to lock to
Dolby Digital:
the embedded audio.
Embedded audio
not present Remedy: Check that the audio channels
are embedded where required. Check the
sources of the embedded audio.
Description: The audio input is nearly
Dolby Digital:
overloaded. The audio input level is too
Overload on the
high and close to the clipping level.
audio input
Remedy: Increase the clipping level or
signal
reduce the input level.
6-8 D9054 HDTV Encoder Intstallation and Operation Guide
Severity Default
Alarm
Category
Information None
Warning None
Minor B
Minor B
Minor B
Minor B
Minor B
4038938 Rev A
Enable
On
On
On
On
On
On
On