Setting Up The Dolby-E Decoder (Mca Card Only) - Cisco D9054 Installation And Operation Manual

Setting up the Dolby-E Decoder (MCA card only)

Note: The Dolby-E Decoder sub-page is only available when the encoder is
equipped with a Multiple Channel Audio (MCA) card and a Dolby-E Decoder
license. This sub-page is not used for dual-channel audio applications.
To Set Up the Dolby-E Decoder
Proceed as follows to set up the Dolby-E Decoder:
1. From the user interface of the D9054 Encoder, click the Audio tab and then the
Dolby-E Decoder icon from the sub-pages:
2. Select in the Input Type field whether your audio input is digital or embedded.
The D9054 Encoder inputs the signal from the digital input connector in the
selected format (digital or embedded). If you select Embedded, the D9054
Encoder extracts the audio embedded in the active HD-SDI video signal of the
program.
3. If Digital was selected as the input type above, select one of the four connectors
to use as the digital audio input (Digital Input). You can select AES1, AES2,
AES3, or AES4.
4. If Embedded was selected as the input type above, select the embedded packet
and pair (Embedded Input). You can select Packet 1 to 4 and Pair 1 or 2.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide 5-85