Chapter 1 Quick Setup - Read Me First; Connecting The Units - Cisco D9054 Installation And Operation Manual

Connecting the Units

Electrical Connection
Proceed as follows to connect the unit:
Alarm
Management
Data Outputs
1. Connect the HD-SDI video input signal to the connector for video - 292M IN.
There are 2 connectors to provide a loop-back possibility. For further
information, see Connecting the Video Inputs, page 3-7.
2. Connect the audio input signals to the CH1 and CH2 IN connectors.
Use a high-quality balanced audio cable. For further information, see
Connecting the Audio Inputs, page 3-8.
3. If relevant, connect the cable from the external alarm system to the alarm
connector. For further information, see Connecting an External Alarm System,
page 3-10.
4. If relevant, for synchronization, connect an external video source to REF IN.
5. Connect the external contact control equipment such as a DTMF decoder to the
contact closure connector. For further information, see Connecting to the
Contact Closure Interface, page 3-9.
4038938 Rev A
Chapter 1
Quick Setup - Read Me First!
Contact Closure
292M In and Out
D9054 HDTV Encoder Installation and Operation Guide
ASI Monitor
ASI Out 1 + 2
External
Reference Not Used
Reference
Outputs
Audio Inputs
1-1