Cisco D9054 Installation And Operation Manual page 245

Message Description and Remedy
TS rate/video Description: The encoding rate is too high
rate mismatch compared to the TS rate or the encoding
rate is too low. The encoding will restart.
Remedy: Check the settings. Change the
encoding rate or increase the TS rate. In a
statmux set-up, the TS rate of an encoder
must have room for the maximum
instantaneous encoding rate. If a FIFO
error occurs recurrently, contact the
closest Cisco customer support center for
assistance.
Video bitrate Description: For the selected video and
error chroma formats, it is not possible to
implement the requested video bit rate.
Remedy: Change video input or chroma
format or check the selected video bit
rate.
Video delay error Description: For the selected video delay,
it is not possible to implement the
requested video delay.
Remedy: Change the video bit rate or
change other video settings to decrease
the end-to-end delay. Alternatively,
increase the specified delay.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide
Severity Default
Alarm
Category
Major B
Major B
Major B
Enable
On
On
On
6-23