Section F - Setting Up The Ts Output; Setting Up The Ts Output Parameters - Cisco D9054 Installation And Operation Manual

Setting Up the TS Output Parameters

To Set Up the TS Output Parameters
Proceed as follows to set up the TS Output:
1. From the user interface of the D9054 HD Encoder, click the TS Output tab.
2. Enter the Output Bit Rate in bit/s.
The legal range is from 1 to 120 Mbit/s. This bit rate must not be smaller than
the Used Payload.
3. Select 188 or 204 bytes mode for the Output Format.
The value must be the same in the encoder and the decoder.
Format
188
204 RS OFF
Note: If you use a modulator you should switch off the RS error correction.
4. Click Apply.
5-96

Section F - Setting Up the TS Output

Meaning
188 bytes mode without Reed Solomon algorithm.
204 bytes mode without the Reed Solomon algorithm applied.
This means that there is RS overhead but only with dummy
bytes.
D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A