Tab Pages - Cisco D9054 Installation And Operation Manual

Tab Pages

Tab Pages

The GUI of the D9054 HD Encoder has a number of tab pages.
The function for the tab pages is as follows:
• Summary
From this page you can get an overview picture of the most important settings in
the D9054 HD Encoder.
• Video
From this page you can set up the
- video input type and resolution
- picture width, the GOP sequence, chroma format, video aspect ratio
- rate for fixed rate (CBR) encoding
- statistical multiplexing parameters such as encoding rate, statmux pools,
redundancy states and monitoring statistics
• Pre-processor
From this page you can set up the pre-analysis and noise reduction parameters.
• Audio
From this page you can set up the audio input parameters such as type,
impedance, sample rate, clipping level, audio encoding mode, bit rates.
• VBI
From this page you enable or disable the various VBI resources.
• DPI
From this page you set up the digital program insertion parameters.
• TS Output
From this page you can set up the output mode, format and bit rate. You can also
set up the parameters for the IP streaming output.
• PSI
From these tab pages you define the PIDs, program names and numbers for the
various program elements.
• System
From this tab page you an read various system parameters such as serial number,
software version number, system uptime, temperatures and slot information. You
can set up trap destinations, see messages and change message settings. You can
also install options and reboot or reset the system to the default settings.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide 5-9