TART UIDE Installing the Cisco Coaxial Media Converter Revised: April 24, 2014, 78-21661-01 Before installing the Cisco Coaxial Media Converter (CMC), review the safety precautions in the Cisco Remote-PHY Solution Installation and Configuration Guide. For more information see: www.cisco.com/c/en/us/td/docs/cable/RemotePhy/InstallConfig/guide/b-remotePHY-install-config-guide.html RJ-45...
291mm Mounting Holes a. Drill four holes in the wall at a distance of 291 mm x 158.4 mm. Align the Cisco CMC horizontally with the holes on the wall and ensure proper ventilation around it. b. Insert an M8 or 5/16” expansion bolt into each hole.
Position the Cisco CMC on the strand and lightly tighten the strand clamp bolts with your finger. b. Move the Cisco CMC on the strand as required for installing the cables and tighten the strand clamp bolts using a torque wrench and ½-inch socket from 5 ft-lb to 8 ft-lb.
For 220V, connect the AC power cord to an AC power source. For 60V, connect the coaxial cable to the CATV IN or Step 6 one of the RF output ports. Then, insert an AC shunt for the coaxial cable. Power on the Cisco CMC. It may take up to three minutes for the Cisco CMC to come Online.