Connecting The Asi Outputs And The Asi Monitor Decoder - Cisco D9040 User And Service Manual

Connecting the ASI Outputs and the ASI Monitor Decoder

To Connect the ASI Outputs
Do as follows to connect to the ASI output:
1. Connect the output signals from the D9040 Encoder connectors ASI OUT 1 and/
or ASI OUT2 to the ASI input connectors of the equipment after the D9040
Encoder.
Use a 75-ohm double-braided cable.
The equipment after the D9040 Encoder could be a Transport Stream
Multiplexer such as the PowerVu Model D9140 Advanced Multilplexer.
Hint: The two outputs are identical and can be used for backup purposes.
2. If you want to check the ASI output signal connect an ASI monitor to the ASI
monitor connector.
Note: The ASI monitor output cannot be muted but otherwise it works just like
the two primary outputs.
3-16 Installation
4020024 Rev C