Oracle Sun Fire X2270 M2 Service Manual page 84

BIOS POST F1 and F2 Errors
Event
Firmware (BIOS) ROM corruption
System restart
Initiated by hard reset
Memory initialization
Primary processor initialization
Initiated by warm reset
Embedded controller management
Secondary processor(s) initialization
Video initialization
Keyboard controller initialization
Option ROM initialization
Option ROM space exhausted
User initiated system set up
User initiated boot to OS
No bootable media
PXE server not found
ACPI Power state
BIOS POST F1 and F2 Errors
Each power-on-self-test (POST) diagnostic is a low-level test designed to pinpoint faults in a
specific hardware component. If a POST diagnostic discloses an F1 or F2 error, it typically
reports the following information about the error:
84 Sun Fire X2270 M2 Server Service Manual • January, 2012, –12
Cause
BIOS checksum fails and the boot block is not corrupted
System boot initiated
Boot process started by hard reset
Memory sizing is occurring
System firmware progress
Primary CPU initialization
System firmware progress
Boot process started by warm reset
Management controller initialization
Secondary CPU initialization asserted
System firmware progress
When BIOS initializes keyboard
When BIOS initializes keyboard
BIOS initializes Option ROMs
System firmware progress
BIOS cannot copy an option to the memory
End user initiated access to BIOS Setup utility
System firmware progress
System boot initiated
System firmware progress
Nothing to boot from
Boot error - PXE server not found
F12 key was pressed but BIOS fails to boot from PXE server
Soft-off power applied
Boot continues on
host?
No
Yes
Yes
Does not apply
Does not apply
Does not apply
Does not apply
Does not apply
Does not apply
Does not apply
Does not apply
Yes
Does not apply
Does not apply
No
No
Does not apply