Maintaining The Sun Fire X2270 M2 Server; Preparing For Service And Operation - Oracle Sun Fire X2270 M2 Service Manual

Maintaining the Sun Fire X2270 M2 Server

This section contains information that describes how to add, replace, and configure
components in the Sun Fire X2270 M2 Server after it has been set up:
"Preparing for Service and Operation" on page 17
■
"Powering On and Powering Off the Server" on page 27
■
"Component Replacement Procedures and Topic" on page 29
■

Preparing for Service and Operation

This section contains important topics and tasks that describe how to safely and properly
prepare your server for both service and operation.
Note –
server approximately every six months or more often in dustier operating environments. Check
system heatsinks, fans, and air openings. If necessary, clean systems by brushing or blowing
contaminants from the system or by carefully vacuuming contaminants from the system. Do
not use liquid cleaners on or in the server.
"Important Safety Information" on page 17
■
"Antistatic Procedures and Precautions" on page 18
■
"How to Use an Antistatic Mat" on page 19
■
"CRU and FRU List" on page 19
■
"Tools and Supplies Needed" on page 20
■
"How to Prepare for Service" on page 21
■
"How to Remove the Server from the Rack" on page 22
■
"How to Install the Server Into the Rack" on page 23
■
"How to Remove the Server Cover" on page 25
■
"How to Install the Server Cover" on page 26
■
"How to Prepare for Operation" on page 26
■
Important Safety Information
This section describes important safety information to know before removing or installing
parts in your Sun Fire server.
System cooling might be affected by dust and contaminant buildup. Open and check the
17