Oracle Sun Fire X2270 M2 Service Manual page 59

Removing and Installing the SP Module (CRU)
This section contains the following topics:
"How to Remove the SP Module" on page 59
■
"How to Install the SP Module" on page 60
■
▼
How to Remove the SP Module
See:
Before You Begin
"Locations of Internal Server Components" on page 30
Prepare the server for service. See
1
Remove the air duct. See
2
Remove any cables that are attached to the rear of the SP module.
3
Completely loosen the captive screw securing the SP module to the server motherboard.
4
Pull the SP module upward to disengage the card from the connector and the alignment pin on
5
the motherboard.
To remove the SP module, slide it slightly forward to clear the rear wall of the server chassis, and
6
then lift the module from the chassis.
If you are replacing the SP module, see
7
Prepare the server for operation. See
8
"How to Prepare for Service"on page
"How to Remove the Air Duct"on page
"How to Install the SP Module"on page
"How to Prepare for Operation"on page
Removing and Installing the SP Module (CRU)
21.
53.
60.
26.
59