Oracle Sun Fire X2270 M2 Service Manual page 63

Install the air duct. See
6
Prepare the server for operation. See
7
"How to Remove the SATA Cable Harness" on page 62
See Also
Replacing the Front I/O Cable (CRU)
This section contains the following topics:
"How to Remove the Front I/O Cable" on page 63
■
"How to Install the Front I/O Cable" on page 63
■
▼
How to Remove the Front I/O Cable
See:
Before You Begin
"Sun Fire X2270 M2 Server Internal Cabling" on page
Prepare the server for service. See
1
Remove the air duct. See
2
Disconnect the I/O cable from the I/O board.
3
Disconnect the two I/O cable connections from the motherboard.
4
Carefully pull the I/O cable through the cutout in the chassis divider and lift it from the chassis.
5
"How to Install the Front I/O Cable" on page 63
Next Steps
▼
How to Install the Front I/O Cable
See:
Before You Begin
"Sun Fire X2270 M2 Server Internal Cabling" on page 61
■
"How to Remove the Front I/O Cable" on page 63
■
Connect the two I/O cable connections to the motherboard.
1
Carefully route the I/O cable through the cutout in the chassis divider and over the top of the HD
2
partition.
"How to Install the Air Duct"on page
"How to Prepare for Operation"on page
"How to Prepare for Service"on page
"How to Remove the Air Duct"on page
Replacing the Front I/O Cable (CRU)
53.
26.
61.
21.
53.
63