Oracle Sun Fire X2270 M2 Service Manual page 70

Removing, Installing, and Adding a CPU and Heatsink (FRU)
If you are not installing a new heatsink, use the alcohol pads to remove any residual thermal
8
compound from the bottom of the heatsink.
Apply thermal compound to the top of the CPU.
9
For best application, use the entire contents of the pre-filled syringe and apply the compound in
a star (asterisk) pattern.
Carefully position the heatsink over the CPU, aligning it with the mounting posts.
10
After the heatsink contacts the CPU, minimize the movement .
Caution –
compound might become uneven, leading to component damage.
To secure the heatsink to the motherboard, alternately tighten the four screws.
11
Alternately turn each screw one full turn until all the screws are tightened fully.
Install the air duct. See
12
Prepare the server for operation. See
13
▼
How to Add a New CPU and Heatsink Assembly
Use this procedure if you are adding a CPU to your server.
See:
Before You Begin
"Locations of Internal Server Components" on page 30
Prepare the server for service. See
1
Remove the air duct. See
2
70 Sun Fire X2270 M2 Server Service Manual • January, 2012, –12
If the heatsink is moved too much during its installation, the layer of thermal
"How to Install the Air Duct"on page
"How to Remove the Air Duct"on page
"How to Prepare for Operation"on page
"How to Prepare for Service"on page
53.
26.
21.
53.