Riso RP3700I User Manual page 92

Printing Originals Side by Side
Make other necessary settings.
8
• The following functions can be specified for each original.
NOTE
• You can recall the saved settings quickly.
Press the Start key.
9
< When printing the same original Multi-Up >
The original is scanned twice or four times and a
sample Multi-Up print is produced.
< When printing multiple originals Multi-Up >
Important!
The Stage Glass and the optional ADF unit cannot be used together in the multiple-originals
Multi-Up printing. If the first original has been scanned with the Stage Glass, therefore, ensure
that the second and subsequent originals are also set on the Stage Glass.
G When the originals are set on the Stage Glass or separately in the ADF unit
Ensure that the [Multi-Up Interval] is set at a value other than [0 second].
After the first original is scanned, a beep sounds to request the next original to be
placed.
During the beep, change the settings if necessary, and place the second original on the
Stage Glass or in the optional ADF Unit. Then press the Start key.
(This procedure must be repeated twice for the [8 Up] and [16 UP] printing.)
G In the ADF unit
A test print will be printed after all originals are scanned.
Important!
There will be half or three quarter blank on the printed copies if :
• The next original has not been set in place during the [Multi-Up Interval].
• The Stop key has been pressed during the operation.
Enter the number of copies to be
10
printed.
Specify the number of copies to be printed using
the Print Quantity keys.
92
- Image processing ([Line], [Duo], [Photo], [Dot], etc.)
- Scanning contrast adjustment.
- Reproduction size (Reduction/Enlargement)
p.124... Storing Settings in Memory
SPEED
SLOW FAST
PRINT
1 2 3 4 5
POSITION
DENSITY
LIGHT DARK
1 2 3 4 5
CENTER
1 2 3
TEST PRINT RESET
START START
STOP