Riso RP3700I User Manual page 185

G01-0451: Paper Jam
The following message will be displayed when documents or paper are jammed inside the ADF unit (optional) or the
printer.
Paper Jam
Check Indicated Areas and
Press [OK] button
The place where paper jam has occurred will be shown by the flashing mark on the graphic. If an error has occurred,
refer to the relevant column below and take action accordingly.
Location and Description
Paper was not fed or was improperly
fed.
An original has jammed in the ADF
Unit (optional).
q Check paper on the Paper
Feed Tray and remove
the jammed paper while
pressing the Paper
Release Lever to the left.
w Reset the paper in place.
e Press the Reset key if the indicator is still flashing.
Pull out the original while
pressing the Original Release
Button to the right.
If the original has been fed too far to be removed from the entrance
side of the ADF Unit, open the unit and pull out the original, while
turning the Original Release Dial at the bottom of the unit or pressing
the Original Feeder Release Lever to the left.
Advisory Messages
Action
Original Release Button
Original Feeder Original Release Dial
Release Lever
185