Riso RP3700I User Manual page 30

Basic Procedure
Press the Start key.
4
After an original is scanned, a master is created.
A sample is automatically printed to allow you to
check the print quality, position and density.
p.69 .. To change the position of the printed
p.68 .. To change the print density of the
If settings are changed, press the Test Print key
to check the results with sample prints.
Enter the number of copies to be
5
printed.
Specify the number of copies to be printed using
the Print Quantity keys; the number is displayed
in the Print Quantity Display.
If you enter a number incorrectly, press
NOTE
the C key to reset the Print Quantity
Display to zero, then enter the correct
number.
Press the Start key again.
6
The specified number of copies is printed.
If printing stops and the "Add Paper"
NOTE
message appears in the Main Display,
paper has run out in the Paper Feed
Tray. Load paper into the tray.
p.67 .. To change the print speed, press the
Press the Reset Key.
7
After printing has finished, press the Reset Key
to restore the initial settings.
30
image, press the Print Position
Adjustment keys on the control panel.
printed copies, change the print
density setting.
Ready to Make Master
Line 100%
Ready to Make Master
Line 100% Auto
Print Speed Adjustment keys.
START
TEST PRINT
Auto A 3
1 2 3
Standard
5
4 6
7 8 9
Volume
0 C
A 3
Standard
START
Volume
Making Master
Image Size Contrast
Line 100% Auto
Duo Auto Manual Standard
Select Print Quantity
Aux. Menu Print Position
10. 0mm 10. 0mm
Renew Page
Standard
Printing
Aux. Menu Print Position
10. 0mm 10. 0mm
Renew Page
Standard St
M
Paper
A 3
M
Paper
A 3
M
Paper
A 3
d d