Riso RP3700I User Manual page 183

B00-000: Errors in Optional Devices
Message
Close Sorter's Cover
Check Sorter's Panel Display
Insert Card in Key/Card Counter
!! Job Separator Has No Power !!
Turn On Power Switch of it
No Paper Tape in Job Separator
Replace Tape Roll
Paper Tape Jam in Job Separator
Remove Paper Tape
A00-000: Other Errors
Message
Check Paper Feed Tray
Master Disposal Error
Pull Out Print Cylinder (Drum) and
Discard Master
Master Jammed in Disposal Unit
Open Scanner Table and
Disposal Top Cover,
then Remove Master
Description
The sorter's (optional) cover
is open.
An error has occurred with
the sorter (optional.)
An operator card has not
been set in place in the Key/
Card Counter (optional.)
The power to the Job
Separator (optional) has not
been switched on.
The Job Separator (optional)
tape has run out.
Paper tape is jammed in the
Job Separator (optional).
Description
The safety switch under the
Paper Feed Tray has been
activated.
A used master remains on
the Print Cylinder (Drum).
A used master is stuck at the
entrance of the Master
Disposal Unit.
Advisory Messages
Action
Close the sorter's cover.
Check the panel on the sorter. (Refer
to the sorter user's manual for details
on operating the sorter.)
Insert an operator card in the Key/Card
Counter.
Turn on the power switch on the Job
Separator.
Set a new tape in the Job Separator.
Check the Job Separator and remove
the jammed tape.
Action
Check the paper feed area for any
obstructions and clear it if an obstacle
is found.
Open the Front Cover, pull out the Print
Cylinder (Drum) and remove the
remaining master. After returning the
Print Cylinder (Drum) to its position,
press the Start key to restart master-
making operation.
p.171... Changing Print Cylinders
(Drums)
Open the Scanner Table and the
Disposal Top Cover, and then remove
the stuck master inside. To open the
Disposal Top Cover, pull the Master
Disposal Unit Release Lever toward you.
Release
Lever
183