Table of Contents
Advertisement
User Manual of DS-9664NI-RH Series NVR
5.8 Configuring Redundant Recording and
Capture
Note:
When the RAID function is enabled, the disk cannot be set to redundancy property. Please refer to
Chapter 10 RAID Configuration for more information.
Purpose:
Enabling redundant recording and capture, which means saving the record files and captured pictures not only
in the R/W HDD but also in the redundant HDD, will effectively enhance the data safety and reliability.
Steps:
1.
Enter HDD Information interface.
Menu> HDD
2.
Select the HDD and click
1)
Set the HDD property to Redundancy.
2)
Click Apply to save the settings.
3)
Click OK to back to the upper level menu.
Note:
You must set the Storage mode in the HDD advanced settings to Group before you set the HDD
property to Redundant. For detailed information, please refer to Chapter 11.4 Managing HDD Group. There
should be at least another HDD which is in Read/Write status.
3.
Enter the Record setting interface.
Menu> Record> Encoding
Figure 5.31 HDD General
to enter the Local HDD Settings interface.
Figure 5.32 HDD General-Editing
61
Advertisement
Table of Contents
