Table of Contents
Advertisement
User Manual of DS-9664NI-RH Series NVR
9.1 Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Steps:
1.
Enter the Network Settings interface.
Menu >Configuration>Network
2.
Select the General tab.
3.
Set the Working Mode.
There are two 10M/100M/1000M NIC cards provided by the device, and it allows the device to work in the
Multi-address, Load Balance and Network Redundancy modes.
Multi-address Mode: The parameters of the two NIC cards can be configured independently. You can select
LAN1 or LAN2 in the NIC type field for parameter settings.
You can select one NIC card as default route. And then the system is connecting with the extranet the data
will be forwarded through the default route.
Network Redundancy Mode: The two NIC cards use the same IP address, and you can select the Main NIC
to LAN1 or LAN2. By this way, in case of one NIC card failure, the device will automatically enable the
other standby NIC card so as to ensure the normal running of the whole system.
Load Balance Mode: By using the same IP address and two NIC cards share the load of the total bandwidth,
which enables the system to provide two Gigabit network capacity.
Figure 9.1 Network Settings Interface
125
Advertisement
Table of Contents
