Table of Contents
Advertisement
User Manual of DS-9664NI-RH Series NVR
10.1.1 Enabling RAID
Purpose:
After enabling the RAID function, you should create and configure the array the before operating the
recording video files.
Steps:
1.
Enter the Advanced interface of HDD disk mode.
Menu >HDD>Advanced
2.
Check the checkbox of Enable RAID to enable the RAID function, as shown in Figure 10.1.
3.
Click Apply, and the following message box pops up:
4.
Click Yes to reboot the device to validate the new settings.
10.1.2 Creating an Array by One-touch Configuration
Purpose:
Through one-touch configuration, you can quickly create the disk array and virtual disk. By default, the array
type to create is RAID5.
Steps:
1.
Enter the Physical Disk interface.
Menu >HDD>RAID>Physical Disk
Figure 10.2 Enable RAID
Figure 10.3 Message Box
142
Advertisement
Table of Contents
