Table of Contents
Advertisement
User Manual of DS-9664NI-RH Series NVR
4.
Configure the other parameters: NIC Type, IPv4 Address, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP
address and other network settings from that server.
Note:
The valid value range of MTU is 500 ~ 9676.
5.
After having configured the general settings, click the Apply button to save the settings.
9.2 Configuring Advanced Settings
9.2.1 Configuring PPPoE Settings
Purpose:
Your NVR also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Steps:
1.
Enter the Network Settings interface.
Menu >Configuration> Network
2.
Select the PPPoE tab to enter the PPPoE Settings interface, as shown in Figure9.3.
3.
Check the PPPoE checkbox to enable this feature.
4.
Enter User Name, Password, and Confirm Password for PPPoE access.
Note:
The User Name and Password should be assigned by your ISP.
Figure 9.2 Load Balance Working Mode
Figure 9.3 PPPoE Settings Interface
126
Advertisement
Table of Contents
