Table of Contents
Advertisement
User Manual of DS-9664NI-RH Series NVR
Select the available physical disk(s) and click OK to confirm the settings. The message box of "Do
4.
not unplug the physical disk when it is under migration" will pop up. Click OK to start migration.
5.
You can enter the Array Settings interface (Menu>HDD>RAID>Array) to check the process of the
migration.
Note:
After the array migration is finished, the array capacity will be refreshed. You need to create new
virtual disk (s) or delete the old virtual disk (s) first and create again so as to ensure the new array capacity to
be used for data storage.
10.6 Unplugging Safely
Purpose:
Under normal working status, if the failure of physical disk existed in the array, you can unplug it safely to
remove the failed disk.
Steps:
1.
Enter the Array interface.
Menu >HDD>RAID>Array
2.
Select the array from the list to be unplugged safely.
3.
Click
to unplug the array safely. And the following message box pops up:
4.
After the array is unplugged safely, all disks of this array will become the normal physical disks.
Figure 10.32 Array Setting Interface
Figure 10.33 Array List
Figure 10.34 Message Box of Unplug Safely
155
Advertisement
Table of Contents
