Table of Contents
Advertisement
User Manual of DS-9664NI-RH Series NVR
2.
Create the array.
1)
Click the Create button to enter the Create Array interface.
2)
Edit the Array Name.
3)
Set the RAID Level to RAID 0, 1, 5 or 10.
4)
Select the initialization type.
Initialization (Background): The background initialization usually takes long time, which
depends on the HDD capacity. During the background initialization, the virtual disk is allowed
to use.
Initialization (Fast): The fast initialization usually takes short time, which is not relevant to the
HDD capacity.
5)
Select the physical disks that you want to configure array.
6)
Click the OK button to finish the array creation.
Note:
If the number of HDDs you select is not compatible with the requirement of the RAID level, the
error message box will pop up.
Figure 10.9 Physical Disk List
Figure 10.10 Create Array
145
Advertisement
Table of Contents
