Table of Contents
Advertisement
User Manual of DS-9664NI-RH Series NVR
2.
Select the physical disks from the list for creating the array.
3.
Click the One-touch Config button to start creating the array.
Notes:
1)
As the default array type to create is RAID 5, at least 3 hard disks must be installed before operation.
2)
When the One-touch Array Configuration is selected, the device can automatically enable the
installed HDDs for array creation. Edit the Array Name and then click the OK button to start array
configuration.
4.
When the array configuration is complete, click the OK button on the pop-up Attention box to finish
the settings.
Notes:
1)
If you install 4 HDDs or above for one-touch configuration, a hot spare disk will be set by default.
Figure 10.4 Physical Disk List
Figure 10.5 Edit Array Name
Figure 10.6 Message Box
143
Advertisement
Table of Contents
