Table of Contents
Advertisement
User Manual of DS-9664NI-RH Series NVR
6.
Select the camera (s) to be configured with the same quota settings. You can also click the checkbox
to select all cameras.
7.
Click the OK button to finish the Copy settings and back to the Storage Mode interface.
8.
Click the Apply button to apply the settings.
Note:
If the quota capacity is set to 0, then all cameras will use the total capacity of HDD for record
and picture capture.
11.6 Checking HDD Status
Purpose:
You may check the status of the installed HDDs on NVR so as to take immediate check and maintenance in
case of HDD failure.
Checking HDD Status in HDD Information Interface
Steps:
1.
Enter the HDD Information interface.
Menu > HDD>General
2.
Check the status of each HDD which is displayed on the list, as shown in Figure 11.20.
Note:
If the status of HDD is Normal or Sleeping, it works normally. If the status is Uninitialized or
Abnormal, please initialize the HDD before use. And if the HDD initialization is failed, please replace it with
Figure 11.19 Copy Settings to Other Camera(s)
Figure 11.20 View HDD Status (1)
169
Advertisement
Table of Contents
