Table of Contents
Advertisement
User Manual of DS-9664NI-RH Series NVR
5.9 Configuring HDD Group for Recording
and Capture
Purpose:
You can group the HDDs and save the record files and captured pictures in certain HDD group.
Steps:
1.
Enter HDD setting interface.
Menu>HDD
2.
Select Advanced on the left bar.
3.
Check whether the storage mode of the HDD is Group. If not, set it to Group.
4.
Click General in the left bar and configure HDD group.
1)
Click General tab in the left bar.
2)
Choose a group number for the HDD group.
3)
Click Apply and then in the pop-up message box, click Yes to save your settings.
4)
Click OK to back to the upper level menu.
Refer to Chapter 11.4 Setting Managing HDD Groups for details.
5.
Choose the Channels which you want to save the record files and captured pictures in the HDD
group.
1)
Select Advanced on the left bar.
2)
Choose Group number in the dropdown list of Record on HDD Group
3)
Check the channels you want to save in this group.
4)
Click Apply to save settings.
After having configured the HDD groups, you can configure the Recording and Capture settings following
the procedure provided in Chapter 5.2-5.7.
Figure 5.35 HDD General
Figure 5.36 HDD Advanced
63
Advertisement
Table of Contents
