Table of Contents
Advertisement
User Manual of DS-9664NI-RH Series NVR
5.3 Configuring Motion Detection Record and
Capture
Purpose:
Follow the steps to set the motion detection parameters. In the live view mode, once a motion detection event
takes place, the NVR can analyze it and do many actions to handle it. Enabling motion detection function can
trigger certain channels to start recording, or trigger full screen monitoring, audio warning, notify the
surveillance center and so on. In this chapter, you can follow the steps to schedule a record which triggered by
the detected motion.
Note:
The encoding is done by the connected front end encoding devices (e.g., camera, dome), herein the
NVR, only provides the configuration panel.
The motion detection must be supported by the connected dome/camera.
Steps:
1.
Enter the Motion Detection interface.
Menu>Camera>Motion
2.
Configure Motion Detection:
1)
Choose camera you want to configure.
2)
Check the checkbox of Enable Motion Detection.
3)
Drag and draw the area for motion detection by mouse. If you want to set the motion
detection for all the area shot by the camera, click Full Screen. To clear the motion
detection area, click Clear.
Figure 5.11 Motion Detection
49
Advertisement
Table of Contents
