Status And Counters Data - HP ProCurve series 2500 Management And Configuration Manual

Status and Counters Data

This section describes the status and counters screens available through the
switch console interface and/or the web browser interface.
N o t e
You can access all console screens from the web browser interface via Telnet
to the console. Telnet access to the switch is available in the Device View
window under the Configuration tab.
Status or Counters Type
Menu Access to Status and
Counters
General System Information Menu, CLI
Management Address
Information
Port Status
Port and Trunk Statistics
Address Table
(Address Forwarding Table)
Port Address Table
STP Information
IGMP Status
VLAN Information
Port Status Overview
Interface
Menu Access menu interface for status and counter data.
Lists switch-level operating information.
Menu, CLI Lists the MAC address, IP address, and IPX network number for
each VLAN or, if no VLANs are configured, for the switch.
Menu, CLI, Displays the operational status of each port.
Web
Menu, CLI, Summarizes port activity.
Web
Menu, CLI Lists the MAC addresses of nodes the switch has detected on the
network, with the corresponding switch port.
Menu, CLI Lists the MAC addresses that the switch has learned from the
selected port.
Menu, CLI Lists Spanning Tree Protocol data for the switch and for individual
ports. If VLANs are configured, reports on a per-VLAN basis.
Menu, CLI Lists IGMP groups, reports, queries, and port on which querier is
located.
Menu, CLI For each VLAN configured in the switch, lists 802.1Q VLAN ID and
up/down status.
Web Shows port utilization and the Alert Log.
Monitoring and Analyzing Switch Operation

Status and Counters Data

Purpose Page
10-4
10-5
10-6
10-7
10-8
10-11
10-11
10-15
10-17
10-18
10-20
10-3