Time Protocols
TimeP: Viewing, Selecting, and Configuring
5. In the Poll Interval field, enter the time in minutes that you want for a
Press
time protocol configuration in both the startup-config and running-config
files.
CLI: Viewing and Configuring TimeP
CLI Commands Described in this Section
Command
show timep
[no] timesync
ip timep
no ip timep
This section describes how to use the CLI to view, enable, and configure TimeP
parameters.
Viewing the Current TimeP Configuration
Using different show commands, you can display either the full TimeP config
uration or a combined listing of all TimeP, SNTP, and VLAN IP addresses
configured on the switch.
Syntax: show timep
For example, if you configure the switch with TimeP as the time synchroniza
tion method, then enable TimeP in DHCP mode with the default poll interval,
show timep lists the following:
9-30
TimeP Poll Interval.
to return to the Actions line, then [S] (for Save) to enter the new
[Enter]
9-32 ff., 9-35
dhcp
manual
server <ip-addr>
interval
This command lists both the time synchronization method
(TimeP, SNTP, or None) and the TimeP configuration, even if
SNTP is not the selected time protocol. (If the TimeP Mode is
set to Disabled or DHCP, then the Server field does not appear.)
Page
9-30
9-33
9-34
9-34
9-35
9-36