Cli: Viewing And Configuring Timep - HP Procurve 2650 Management And Configuration Manual

Time Protocols
TimeP: Viewing, Selecting, and Configuring
8-16
Note: This step replaces any previously configured TimeP server
IP address.
iii. Press [ >] to move the cursor to the
step 6.
6. In the field, enter the time in minutes that you want for a TimeP
Poll Interval
Poll Interval.
Press to return to the Actions line, then
time protocol configuration in both the startup-config and running-config
files.

CLI: Viewing and Configuring TimeP

CLI Commands Described in this Section
show timep
[no] timesync
ip timep
dhcp
manual
server <ip-addr>
interval
no ip timep
This section describes how to use the CLI to view, enable, and configure TimeP
parameters.
Viewing the Current TimeP Configuration
This command lists both the time synchronization method (TimeP, SNTP, or
None) and the TimeP configuration, even if SNTP is not the selected time
protocol.
show timep
Syntax:
page 8-16
page 8-17 ff., 8-19
page 8-17
page 8-18
page 8-18
page 8-19
page 8-20
field, then go to
Poll Interval
(for ) to enter the new
Save