Disabling Interfaces From Sending Ospf Packets - H3C S7500E Series Operation Manual

Operation Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Follow these steps to configure the LSA generation interval:
Enter system view
Enter OSPF view
Configure the LSA
generation interval
Note:
With this command configured, when network changes are not frequent, LSAs are
generated at the minimum-interval. If network changes become frequent, LSA
generation interval is incremented by incremental-interval•2
generation times) each time a generation occurs, up to the maximum-interval.

3.7.7 Disabling Interfaces from Sending OSPF Packets

Follow these steps to disable interfaces from sending routing information:
Enter system view
Enter OSPF view
Disable interfaces from
sending OSPF packets
To do...
system-view
ospf [ process-id |
router-id router-id ] *
lsa-generation-interval
maximum-interval
[ initial-interval
[ incremental-interval ] ]
To do...
system-view
ospf [ process-id |
router-id router-id ] *
silent-interface { all |
interface-type
interface-number }
Use the command...
Use the command...
3-36
Chapter 3 OSPF Configuration
Remarks
—
Required
Optional
By default, the maximum
interval is 5 seconds, the
minimum interval is 0
milliseconds and the
incremental interval is
5000 milliseconds.
n-2
(n is the number of
Remarks
—
—
Optional
Not disabled by default