Specifying A Rip Neighbor; Configuring Rip-To-Mib Binding - H3C S7500E Series Operation Manual

Operation Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches

2.4.7 Specifying a RIP Neighbor

Usually, RIP sends messages to broadcast or multicast addresses. On non broadcast
or multicast links, you need to manually specify RIP neighbors. If a specified neighbor is
not directly connected, you must disable source address check on incoming updates.
Follow these steps to specify a RIP neighbor:
Enter system view
Enter RIP view
Specify a RIP neighbor
Disable source address
check on incoming RIP
updates
Note:
You need not use the peer ip-address command when the neighbor is directly
connected; otherwise the neighbor may receive both the unicast and multicast (or
broadcast) of the same routing information.

2.4.8 Configuring RIP-to-MIB Binding

Follow these steps to bind RIP to MIB:
To do...
Enter system view
Bind RIP to MIB
To do...
system-view
rip [ process-id ]
peer ip-address
undo
validate-source-address
Use the command...
system-view
rip mib-binding
process-id
Use the command...
––
Optional
By default, MIB is bound to the
RIP process with the smallest
process ID
2-16
Chapter 2 RIP Configuration
Remarks
––
––
Required
By default, RIP sends no
updates to any IP
address.
Required
Not disabled by default
Remarks