Install The Lens - Christie Mirage WQ-L User Manual

Install the Lens

C AU TI O N / è è
R i sk G r oup 2/ q³I§ q³I§
Possi bl e hazar dous opt i cal r adi at i on
em i t t ed f r om t hi s pr oduct .
,§ÁïýÑúqi„I
D o not st ar e at oper at i ng l am p.
M ay be har m f ul t o t he eyes.
÷ÿ ÝÆå\-„oˇ ï ý$³¨„<[ ÷ÿ ÝÆå\-„oˇ ï ý$³¨„<[
Failure to comply with the following may result in equipment damage:
• Do not insert the lens at an angle.
• Always replace the lens plug when transporting to protect the optical components.
• Always place the lens cap onto the lens when transporting to avoid scratching the lens.
• Never operate the projector without a lens.
• A small amount of dust or dirt on the lens has minimal effect on image quality. To avoid the
risk of scratching the lens, clean only if absolutely necessary. See
page 62.
1. Remove the lens plug from the lens opening.
2. Remove the rear lens cap from the lens.
3. Rotate the lens clamp to the open position.
4. Remove and retain the two security screws from the lens mount.
5. Align the lens interface plate with the lens mount. Fully insert the assembly straight into the
lens mount opening without turning.
6. Rotate the lens clamp to the closed position before fastening the security screws.
Security screw
Lens clamp
(closed position)
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
Risk Group 2: Possible hazardous optical radiation emitted from this product.
Do not stare at operating lamp. May be harmful to the eyes. Failure to comply
could result in minor or moderate injury.
2 2
For some installations security screws are required on the lens.
Installation
Cleaning the Lens on
Security screw
16