Fine-Tune Projector Colors With A Color Meter - Christie Mirage WQ-L User Manual

A synchronized projector automatically starts listening to its IR receiver if the master projector
becomes unavailable, for example if it goes into Standby mode. Independent indicates that the
projector listens to its own IR remote receiver. It is the default option. Change this setting for
each projector individually.
ArrayLOC network communication overrides RS232 serial communication for keys.
5. When you want to sync the particular feature for all the projectors in the ArrayLOC group, set
fields 4 to 7 to Synchronized.
Use the Independent setting to make changes to each projector individually independent of
the master projector. The default setting for each selection is Synchronized.

Fine-tune Projector Colors with a Color Meter

To use a color meter for projector color adjustments, follow the instructions in
White Brightness, or Primary Colors
the XXX Part of YYY adjustments.
1. To note the xy color values reported for the common gamut, navigate to Main Menu >
ArrayLOC > Array Color Target.
2. Measure the projected primary color with the meter and compare the metered values to the
common gamut values.
Use the adjustment guide to determine how to adjust the Projector Color Adjustment values to
correct the differences. The adjustment guides are color coded. The suggested corrections are also
color coded, and reflect the direction of the change, + or -. For example, if the measured red is 660,
325 and the Common Gamut value is 640, 330 then the measured x is high (High X) while the
measured y is low (Low Y). The corresponding quadrant of the RED guide indicates +G (increase green)
to correct the mismatch with other projectors.
Once you have made an adjustment, re-measure and refer to the guide for the next adjustment.
Repeat until the desired color accuracy is achieved.
1
some corrections require both red and green adjustments.
2
alternative: decrease blue (-B) instead of increasing red and green.
3
alternative: increase blue (+B) and increase green (+G) instead of decreasing red and increasing green.
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
on page 45. Use the information below and a color meter for
Operation
Fine-tune Whites,
46