Table of Contents
Advertisement
•
Access Level: Operator
Examples
Returns the 3D Mode value on main video.
TDM?
Set 3D Mode to 'Off' on main video.
TDM 0
Set 3D Mode to 'Dual Input 3D'.
TDM 3
Invert 3D Input (TDN)
Adjust the output 3D emitter delay to match the active glasses to the L/R frames of the projector. Proper adjustment
of this delay will eliminate cross talk and odd colors caused by timing differences between the glasses and the
projected image. The user specified delay is added after sync locking.
Parameters
•
Control Group: Preference
•
Subclass: Power Up
•
Access Level: Operator
Examples
Returns the 3D input inversion value on main video.
TDN?
Set 3D input inversion to 'inverted' on main video.
TDN 0
3D Sync Out (TDO)
This defines if the 3D Sync is output and controls how it is processed. Typically only the last
projector in the 3D Stereo cable chain is connected to the emitter and should specify "To Emitter".
All Other projectors should select "To Next Input" if other projectors are used in the chain.
Parameters
•
Control Group: Preference
•
Subclass: Power Up
•
Access Level: Operator
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
Serial Command Reference
103
Advertisement
Table of Contents
