Configure Bright/Colorloc - Christie Mirage WQ-L User Manual

Data projector

Table of Contents

2. Check Synchronize to This Projector to make the current projector the master.

Changes you make in the Array Color Target, Bright/ColorLOC Configuration, and RGB

and IR Brightness Targets on the master projector are broadcast to the other projectors in

the array.

The master projector has access to most settings under the Bright/ColorLOC Configuration and

Array Color Target submenus. These settings are greyed out on the other projectors in the

array to prevent conflicting information from being sent.

While working in the ArrayLOC menu and submenus, ArrayLOC displays a warning if

adjusted settings fall outside the range the system can adjust for.

Warnings include:

• Minimum brightness not met (BCLOC disabled)

• Minimum brightness not met (Warning)

• Min Gamut not met (BCLOC disabled)

• Min Gamut not met (Warning)

3. Enable Bright/ColorLOC Mode to automatically achieve and maintain a target gamut and

brightness. See

A projector with Bright/ColorLOC mode disabled ignores BCLOC changes from the master

projector. If at any point you are working with a slave projector you may not be able to

change some settings as they will be locked (grayed out). To change which projector is the

master check the Synchronize to This Projector option on another projector.

4. RGB and IR Brightness Target fields are typically only enabled on the master unless the

system is not synchronized.

See

Configure ArrayLOC

5. Select Auto Color Enable and Test Pattern Enable. The system (background) color changes

to the target color being adjusted.

For example:

•

Red/green/blue part of red changes the system color to red.

•

Red/green/blue part of green changes the system color to green.

•

Red/green/blue part of blue changes the system color to blue.

All other menu options change the system color to white as long as Test Pattern Enable is

checked. The color resets automatically when you exit the menu.