Table of Contents
Advertisement
In response to the 3D Sync Out signal from the projector (BNC A), the infrared emitter emits a
signal to the receiver in the active 3D shutter glasses. This synchronizes the active glasses to open
and close for the active stereo 3D content. The left/right synchronization signal is connected to BNC
B on the projector, which is necessary for 3D frame doubled input configurations.
Passive Stereo 3D Configuration
This diagram shows the typical hardware configuration for passive stereo 3D systems:
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
Secondary input (only required with Dual Input mode)
E
Left/Right synchronization signal (only required for
F
Frame Doubled input)
3D Stereo Sync Cable
G
Output
H
A
H
G
Passive Polarizing Glasses
A
Polarization Maintaining Screen
B
Active Filter Cell
C
Server with Stereo 3D-capable graphics card
D
DVI
E
3D Stereo Sync Cable
F
Left/Right Synchronization Signal
G
Output
H
IMAGE
IMAGE
B
C
E
D
F
Operation
56
Advertisement
Table of Contents
