Table of Contents
Advertisement
ArrayLOC Network
The ArrayLOC Network connector provides a method of interfacing multiple projectors in an array to
manage preliminary color setup. For details, see
ArrayLOC
on page 41.
Connect to Power
013- 102318- 01 R EV 02
Do not operate if the AC supply and cord are not within the specified voltage and power
range. The North American rated line cord is supplied with this projector. For all other
regions, use only a regionally approved line cord, power plug and socket. Do not use a
damaged line cord. Failure to comply could result in death or serious injury.
In Norway, for IT power distribution systems, a dedicated protected earth wire must be
installed on the projector before it can be connected to power. The dedicated earth wire
must be installed by a Christie accredited service technician. To connect the projector to an
IT power distribution system connect the building ground to the internal ground lug behind
the AC input inside the projector. It is recommended that you run the connection through
the louvers on the projector. Failure to comply may result in equipment damage.
The appropriate regional line cords are shipped separately.
1. Connect an approved line cord to the projector AC receptacle. Make sure the security clip is
latched onto the cord.
2. Connect the three-pronged end of the line cord to a grounded AC outlet. The outlet must be
near the equipment and easily accessible.
3. Flip the power switch on the back of the projector. The projector takes approximately two
minutes to initialize. The status light on the input panel turns yellow.
4. Power on the device.
•
Press Power, and then the up arrow from the IR remote.
•
From the WebUI select Power > On from the Main tab.
5. Press an input key on the IR remote to select and display the image for the connected source.
Disconnect Power
Do not flip the main Power switch to the Off position, or disconnect the projector until the
cooling fans have stopped. Failure to comply may result in equipment damage.
1. Power off the device.
•
Press Power, and then the down arrow from the IR remote.
•
From the WebUI select Power > Off from the Main tab.
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
ArrayLOC Network Configuration
Always power down and disconnect/disengage power before servicing or cleaning
Failure to comply could result in death or serious injury.
Installation
on page 25 and
21
Advertisement
Table of Contents
