Connect A Source - Christie Mirage WQ-L User Manual

• Offsets are subject to ±7% centering tolerance.
• % offset is defined as:
The horizontal position of the image can also be offset (moved to the left or right of the optical
center) by adjusting the lens mount. The amount of horizontal offset available depends on the lens
installed and if the image has already been vertically offset. Horizontal offset can be expressed as
the percent of half the image width or the number of pixels of shift to one side of lens center.
1280 pixels
display to left
of lens center
0% Offset
In this example, no offset is applied.
Therefore, half of the image appears to the
left of lens center and half appears to the right.

Connect a Source

All source connections are made to the input panel, located at the back of the projector. Each input
is labeled for easy identification. Using the correct cable(s), connect your source. See
Setup for External Communications
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
% Offset = # of pixels of offset
half vertical panel resolution
1280 pixels 640 pixels
display to right to left of
of lens center lens center
In this example, 50% offset is applied.
on page 22.
x 100
1920 pixels displayed to
right of lens center or 480 pixels
of shift to the right of lens center
50% Offset
Shaded area = projected area
Therefore, 3/4 or 75% of the image
appears to one side of the lens center.
Installation
Network
19