Set Up The Mirage Wq-L To Display 3D Content - Christie Mirage WQ-L User Manual

For operation with passive glasses, a 3D polarization filter is placed in front of the lens and is
synchronized to the projected frames with the 3D Sync Out signal (BNC A). The left/right
synchronization signal is connected to BNC B on the projector, which is necessary for 3D frame
doubled input configurations.

Set Up the Mirage WQ-L to Display 3D Content

The projector must be installed to correctly display 2D content (optically aligned, focused, etc.)
before configuring the 3D content:
1. Connect the 3D equipment to the projector using the instructions provided with the 3D
equipment.
2. Click Main Menu > Image Settings > 3D Settings.
3. Select 3D Mode as Dual Input or Frame Doubled, according to how the source is connected
to the projector.
4. Configure your 3D source.
5. For Dual Input mode, use the Main Input field and select Input 1 or Input 2 for the left eye
and set the Secondary Input to the other input for the right eye.
6. For 3D Frame Doubled mode, set the 3D Sync Input to the External if a sync signal is
connected, or Internal if no 3D sync signal is connected to the projector.
7. To enable the 3D Sync output, set the 3D Sync Output to the To Emitter selection, or To
Next Input for a projector array.
8. Set the last projector in the array to To Emitter.
9. Display the 3D Test Pattern.
If you can see both a grid and a checkerboard test pattern superimposed with each eye,
increase the Dark Interval until a different test pattern is visible on the left eye and the right
eye.
10. To minimize the ghosting of the two patterns with respect to one another, adjust the 3D Sync
Output delay as necessary.
The delay adjusts when the sync pulse is sent to the emitter with respect to the dark time
transition on the DMDs.
11. To reverse the left and right eye images, select Invert 3D Input.
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
Operation
57