Advanced Color Setting (Rgb); Real Time Events (Rte) - Christie Mirage WQ-L User Manual

Advanced Color Setting (RGB)

RGB
Preference
CONTROL GROUP:
Description
Adjusts native projector color space by adjusting the LED power levels. This can be used when ColorLOC is
disabled or if ColorLOC is running in Native or Fixed mode. Care should be exercised when adjusting these
settings as it is possible to overdrive the LEDs and may cause the projector to perform a safety shutdown.
Subcode
CLRM
ROFR
GOFG
BOFB
RGBB
COPY
Examples:
(RGB+ROFR 128) Set Red of Red value.
(RGB+BOFB ?) Get Blue of Blue value.
(RGB+RGBB 500) Set overall brightness to 50%.
(RGB+CLRM 4) Select user preset 2.
(RGB+COPY 2) Copy EBU preset values to current preset.

Real Time Events (RTE)

RTE
Unsaved
CONTROL GROUP:
Description
Real time events allow custom user actions to occur based on a system trigger. There are various triggers in the
system such as power up, input change, errors, or based on time. Time can be absolute, (e.g. 12:00:00 on
December 25, 2008) or relative (e.g. 5 hours and 30 minutes from now).
Special Function keys can also be used as a trigger. An example would be pressing
Events can also be connected to external hardware triggers via the General Purpose IO port (GPIO).
Events:
Single Occurrence Events:
(RTE T YYYY/MM/DD HH:MM:SS S "description" "command")
Daily Occurring Event:
(RTE T YYYY/MM/DD HH:MM:SS YYYY/MM/DD D R "description" "command")
Where the first date and time is the start date and occurrence time. The second date is the end date.
R is the "Repeat Every" interval i.e. repeat every R days
Mirage WQ-L User Manual
020-101372-01 Rev. 1 (04-2014)
Power Up
SUBCLASS:
Description of Use
Color Mode. Selects:
1 = Native
2 = EBU
3 = User preset 1
Red part of red (0-4095)
Green part of green (0-4095)
Blue part of blue (0-4095)
Controls overall brightness of LEDs (0-1000) percentage with
one decimal place
Copies color mode settings from an existing preset to the
current preset. Values:
1 = Copy from Native
2 = Copy from EBU
3 = Copy from User 1
Power Down
SUBCLASS:
Serial Command Reference
Operator
ACCESS LEVEL:
4 = User preset 2
5 = User preset 3
6 = User preset 4
4 = Copy from User 2
5 = Copy from User 3
6 = Copy from User 4
Operator
ACCESS LEVEL:
F
UNC
+1 on the remote.
96